ETC Express 48/96 - Editing a subroutine; Deleting a step; Inserting a step

210 Chapter 16 Effects
Inserting steps
You may insert a new step in place of an existing one in an effect. The
inserted step takes the place of the selected step and other steps are
renumbered. For instance, if inserting a step at number 5, the existing
step 5 becomes step 6; step 6 becomes step 7, and so on. The timing and
level settings from step 4 are set as initial settings in the new step 5.
For example, to insert a step between steps 4 and 5, follow these steps:
Keystrokes:
Action:
1. Press [Blind] [Cue] [2].
Selects cue 2
2. Press [S7], More
Softkeys.
3. Press [S5], Insert Step.
Prompt reads:
Select step number to insert, then
press ENTER
To cancel, press CLEAR
4. Use the [↑] and [↓] keys to
highlight the step you wish
to insert
or…
Enter the number of the
step.
Prompt reads:
Select step number to insert, then
press ENTER
To cancel, press CLEAR
5. Press [Enter].
Prompt reads:
Select channel number(s) and press
ADD CHANNELS to add to step(s),
or press AT to edit existing channel
level(s)
6. Add channels using one of
the techniques available.
7. Press [Record] [Enter].
Records your changes to the cue