298 Chapter 25 Control interfaces
Deleting time code events
Follow these steps to delete time code events:
114
Inserting time code events
Insert a time code event into an existing time code program with this
procedure:
Keystrokes: Actions:
1. Press [S7] until [S6] reads
Delete Event.
2. Press [S6], Delete Event.
Prompt reads:
Select event number(s) to delete,
then press ENTER
To cancel, press CLEAR
3. Press [5] [And] [6] [Enter].
Enters events 5 and 6 to delete
Prompt reads:
To confirm, press ENTER
To cancel, press CLEAR
4. Press [Enter] to delete the
event or [Clear] to leave it
unchanged.
114.
The
Clear Time Code Events
menu option on the Clear Functions menu allows
you to delete all recorded time code events. To do so, press [Setup] [4] [Enter]
[1][3] [Enter] [Enter].
Keystrokes:
Actions:
1. Press [S7] until [S1] reads
Insert Event.
2. Press [S1], Insert Event.
Prompt reads:
Select event number to insert, then
press ENTER
To cancel, press CLEAR
3. Press [4] [Enter].
a
a. The new event(s) will be inserted before event 4.
Prompt reads:
Select number of events to insert,
then press ENTER
To cancel, press CLEAR
4. Press [2].
Indicates that you wish to insert two
new events
Corner reads:
Insert 2
5. Press [Enter].
New events 4 and 5 are inserted; all
following events are renumbered
To Next Page
Loading...
