Express Two Scene Preset User Manual, v.3.1 203
Adding grouped channels
The procedure for creating steps in the Blind Effects display by adding
grouped channels from cues or submasters to them is shown below. All
channels in a group or focus point are added to the step(s) together but
they may be edited individually later.
Keystrokes: Actions:
1. Press [S1], Step, and enter
the step number. A new
step must always have the
next highest number,
beginning with step 1.
Specifies next step to be created.
Prompt reads:
Select step number(s)
(To clear step(s), select step
number(s), then press CLEAR)
2. Press [Group] [Cue] [5]
[Thru] [1][0].
a
a.
To add grouped submasters rather than grouped cues, press
[Submaster] rather than [Cue] in this step.
Selects the channels of cues 5 through
10. Prompt reads:
Group mode - Select focus point(s)
and press ADD CHANNELS to add
to step(s), or press AT to edit
existing channel level(s)
3. Press [S8], Add
Channels, [At] [5][0].
Adds channels to step at level 50
Prompt reads:
Group mode - Select focus point(s)
and press ADD CHANNELS to add
to step(s), or press AT to edit
existing channel level(s)
4. Press [Record] [Enter].
Records the channels to the effect
step. Prompt reads:
Select cue number
To write effect, press STEP
To Next Page
Loading...
