142 Chapter 12 Focus points
Recording a focus point
You can create a focus point in Stage, Blind or Fader displays using all the
same techniques available to create groups.
Recording a focus point in Stage
The following example illustrates the creation of a focus point containing
settings for the intensity and position attributes of several fixtures. Note
the use of Only to conveniently identify the position category.
Creating a focus point from a look on stage
To create a focus point from the look that is already on stage, follow these
steps:
Keystrokes: Action:
1. Press [Stage]. Selects the Stage display
2. Press [S8], Fixture, [1]. Selects fixture 1
3. Set intensity, pan and tilt
levels.
4. Press [+], [–] or [S8] to
select another fixture.
5. Repeat steps 3-4. Repeat procedure for all fixtures to be
included in the focus point
6. Press [Record] [Focus
Point].
7. Press [3]. Enters number of focus point
8. Press [Enter]. Records focus point 3
Keystrokes: Action:
1. Press [Stage]. Selects Stage display mode
2. Press [Record] [Focus
Point].
Prompt reads:
To record focus point, select number
and press ENTER
To cancel, press CLEAR
3. Press [2]. Enters the focus point number you
want to record
Corner reads: Focus 2
4. Press [Enter]. Records focus point 2
To Next Page
Loading...
