Express Two Scene Preset User Manual, v.3.1 57
Setting channel levels
You assign output levels to channels using the basic format [Channel] [#]
[At] [#] where the first number is the channel and the second is the level.
For example, [Channel] [4] [At] [7][5] sets channel 4 at 75 percent. If you
enter a single digit for the level, the console multiplies it by ten and you
must follow it with [Enter]. In other words, [Channel] [4] [At] [1] [Enter]
sets channel 4 to 10 percent. To set channel 4 to 1 percent, enter
[Channel] [4] [At] [0][1].
29
Channel sliders
Your console has two rows of numbered channel sliders. Each channel
slider controls the level of a channel. The sliders on the top row have a
single number, indicating the channel they control. The sliders on the
bottom row have two numbers. The larger number indicates which
channel they control when the console is in one scene mode. The smaller
number indicates which channel they control when the console is in two
scene mode.
On the Express 24/48, in one scene mode, you may also set the bottom
row of sliders to be submasters instead of channel sliders. See Scene
mode, page 30 for more information.
Trackpad
To set channel levels with the trackpad, select the channels whose levels
you want to modify, then move your finger up or down on the trackpad to
set the desired output level.
There are two ways to select channels for trackpad adjustment. You can
specify them on the keyboard or you can select all those channels at once
whose levels are above zero. As an example of the first of these, press
[Channel] [1] [Thru] [5]. To select all non-zero channels, press [Enter].
Full
Press [Full] to set selected channel levels to 100 percent. For example,
press [Channel] [1] [Thru] [3] [Full] to set channels 1, 2 and 3 to 100
percent.
Level key
[Level] sets selected channel levels to the output level assigned to the
[Level] key. The default value for [Level] is 100 percent. (See Setting
default Level key, page 25, for instructions on changing the Level key’s
setting.) For example, if Level is set at 75 percent, press [1] [Thru] [5]
[Level] to set channels 1, 2, 3, 4, and 5 to 75 percent.
Flash
Flash sets the selected channel’s level to 100 percent if the channel is
currently at a level at or below 50 percent. If the channel’s level is above
50 percent, Flash sets it to zero. Levels set by Flash are only maintained
while the key is pressed. For example, press [Channel] [5], then press and
hold [S8], Flash, to set channel 5 to either 100 or zero.
29.
To clear channels, press [At] [Clear].
To Next Page
Loading...
