116 Chapter 9 Multipart cues
Adding, deleting and modifying channels
Follow these steps to edit channels in a multipart cue:
Using Update
With Update, you can do live editing of cue parts in Stage and see the
results immediately on stage. Use the procedure below to add channels
and set levels, assuming you previously created multipart cue 1.
Keystrokes:
Action:
1. Press [Blind].
Selects Blind display mode
2. Enter the cue number.
Prompt reads:
Select cue number
To select cue type, press TYPE
3. Press [S7], More
Softkeys, until Part
appears as softkey [S1].
Finds the Part softkey
4. Press [S1], Part, then
press [+] or [–] until the
desired part is displayed.
Prompt reads:
Select part number
5. Press [Channel], and
select the desired
channels.
Prompt reads:
Select channel numbers
6. Set channel levels. Press
[At] [Clear] to delete the
selected channels.
If the channels are new, this adds
them to the part at the level indicated.
If already in the part, this modifies their
level
7. Press [S7], More
Softkeys, until Part
appears as softkey [S1].
Finds the Part softkey again
8. Press [Record] [S1], Part,
[2] [Enter].
Records the changes into part 2 of the
cue
Keystrokes:
Action:
1. Press [Stage]
Selects stage display
2. Press [S8], Fixture, [4]
Selects fixture 4
3. Set intensity, pan and tilt
levels.
4. Press [S2], Update.
Prompt reads:
To update cue, select number and
press ENTER (TRACK + ENTER for
tracking)
To cancel, press CLEAR
5. Press [Cue] [1].
Selects multipart cue 1 to update
6. Press [S7], More
Softkeys, until Part
appears as softkey [S1].
Finds the Part softkey
7. Press [S1], Part, [2]
[Enter].
Updates part 2 of cue 1
To Next Page
Loading...
