Express Two Scene Preset User Manual, v.3.1 335
Appendix C
Error messages
Diskette error messages
Bad Disk
Disk is unformatted or defective. Try formatting it. If that doesn’t work, try
a different disk.
Corrupted Disk
This disk is defective. Try formatting it. If that doesn’t work, try a different
disk.
Data not recorded on disk
You cannot read the System Configuration settings from showfiles
created with software Version 3.02 or earlier. You must save the show
with 3.03 or later software to include System Configuration settings.
Disk controller failure
Call ETC Technical Service at the office nearest you.
Disk full
Disk contains other files. Remove enough files to make room for show
file.
File not found
This disk does not appear to have a show stored on it. Please confirm that
you have inserted the correct disk.
No disk in drive
Show diskette must be inserted in the diskette drive before you can save
or read a show.
Unknown disk error - try again
Try the diskette again. If it fails again, call ETC Technical Service at the
office nearest you.
Write-protected disk
The write-protect tab on this diskette is open. Close the tab to unprotect
the diskette.
Other error messages
Out of memory
You have used up all system memory allotted to the function with which
you are working. Delete unnecessary parts of the show to free up
memory. If this doesn’t work, you may want to break the show into two
shows, one for each act. This message may also appear if you attempt to
run too many effects.
To Next Page
Loading...
