Express Two Scene Preset User Manual, v.3.1 169
Copying submasters
You can copy a look from a submaster to another submaster, to a cue, a
group or a focus point. Follow the procedure below:
Loading cues or groups to submasters
[Load Sub] allows you to load the contents of one or more recorded
groups or cues into submasters.
To load a look from a range of cues or groups to submasters, follow these
steps:
Keystrokes: Actions:
1. Press [Blind]. Selects Blind display mode
2. Press [Sub]. Prompt reads:
Select submaster number
To select submaster type, press
TYPE
3. Enter the number of the
submaster you wish to
copy.
Corner reads:
Sub 1
4. Press [Record] [Sub].
a
a.
To copy the submaster to a cue, group or focus point, press
[Cue], [Group] or [Focus Point] in place of [Sub] in step 4.
Prompt reads:
To record submaster, select number
and press ENTER
To cancel, press CLEAR
5. Enter the number of the
new submaster.
Corner reads:
Sub 9
6. Press [Enter]. Submaster
copy is complete.
Contents of submaster 1 are copied to
submaster 9
Keystrokes: Actions:
1. Press [Load Sub].
Prompt reads:
Select submaster(s) to load
To cancel, press CLEAR
2. Press [9] [Thru] [1][2].
Selects submasters 9 through 12
Corner reads: Sub 12
3. Press [Cue] (or [Group]).
Prompt reads:
Select cue(s) to load into
submaster(s)
To cancel, press CLEAR
4. Press [1] [And] [3] [Thru]
[5].
Selects cues 1, 3, 4, and 5 to copy to
submasters 9 through 12
Corner reads: Cue 5
5. Press [Enter]. Submaster
copy is complete.
Contents of cues 1, 3, 4, and 5 are
copied to submasters 9, 10, 11, and
12, respectively
To Next Page
Loading...
