ETC Express 48/96 - Remote Trigger

Express Two Scene Preset User Manual, v.3.1 307
Remote trigger
The remote trigger function allows you to program a macro to send an On
or Off signal to any external device that responds to a remote contact
closure. This signal can control any external event (for example, a sound
machine or a bubble machine).
To create a simple remote trigger macro, follow these steps:
Keystrokes:
Action:
1. Press [Setup].
Selects Setup display screen
2. Select 8, Macro Editing,
and press [Enter].
Selects Macro display screen
Prompt reads:
Select macro number, then press
ENTER
3. Press [1][0] [Enter].
Macro 10 created
Prompt reads:
Select operation(s) for this macro –
press ENTER MACRO when done
(Wheels and sliders are not valid
entries in macros)
4. Press [S7] More Softkeys,
[S3], On Trigger.
Enters an On Trigger command
Macro contents line reads: OnTrigger
5. Press [S8], Macro Wait, [5]
[Enter].
Enters a macro wait of 5 seconds
Macro contents line reads:
OnTrigger Mwait-5
6. Press [S4], Off Trigger.
Enters an Off Trigger command
Macro contents line reads:
OnTrigger Mwait-5 OffTrigger
7. Press [Enter Macro].
Saves macro. Macro 10 sends an On
Trigger command, waits five seconds,
then sends an Off Trigger command