ETC Express 48/96 - Working with Sensor Backup Looks; Recording a Backup Look

Express Two Scene Preset User Manual, v.3.1 275
Working with Sensor backup looks
A backup look is a recording of a selected look on stage stored in the
Sensor CEM. The Sensor system allows you to use either your console or
any CEM to bring that look up on stage. You may save and use up to 32
backup looks.
Recording a backup look
To record a backup look, follow these steps:
Keystrokes:
Action:
1. Use your console to create
the desired look on stage.
Creates look on stage
2. Press [Setup].
Selects Setup display
3. Select [9], ETCLink
Functions, and press
[Enter].
Selects ETCLink Functions menu
4. Press [1], Dimming
System Status, [Enter].
Selects System Status display
5. Press [S3], Record
Backup.
Prompt reads:
Select backup look to record, then
press ENTER
6. Enter the backup look
number (1-32) and press
[Enter].
Advisory reads:
Record Backup processing has
completed. Press [Clear] to
continue.