ETC Express 48/96 - Selecting One-To-One Patch

36 Chapter 4 Patching channels
Selecting one-to-one patch
The one-to-one patch assigns dimmer 1 to channel 1, dimmer 2 to channel
2 and so on. If there are more dimmers than channels, the one-to-one
patch assigns the first extra dimmer to channel 1, the second extra
dimmer to channel 2, and so on.
NOTE: Selecting the one-to-one patch unpatches all moving light fixtures.
Follow these steps to select the console's default one-to-one patch.
Keystrokes: Action:
1. Press [Setup] to display
the Setup menu.
Selects Setup display
2. Press [4], Clear Functions
[Enter].
Prompt reads:
Select function number, then
press ENTER
3. Press [9], Reset Patch
1 to 1 [Enter].
Prompt reads:
To reset patch, press ENTER
To cancel, press CLEAR
4. Press [Enter] to confirm
your selection of one-to-
one default patch, or press
[Clear] to cancel the
operation.
Sets patch to default one-to-
one patch