138 Chapter 11 Groups
Using cues and submasters as groups
You may treat channels recorded in a cue or submaster as if they were in
a group, such as to bring them up in Stage or record them into other cues
or submasters.
63
For example, follow this procedure to bring up a cue in Stage as a group:
63.
You may not use this procedure to group the channels in a cue part, an effect cue
or an effect submaster.
Keystrokes: Actions:
1. Press [Stage]. Selects Stage display mode
2. Press [Group]. Tells the console to treat the next entry
as a group
Prompt reads:
Group mode – Select group number
to use as group
3. Press [Cue] and enter the
number of the cue you
want to bring up.
a
a. To use a submaster as a group, follow the same procedure,
but press [Sub] instead of [Cue] in step 3.
Prompt reads:
Group mode – Select cue number to
use as group
4. Press [At] and enter the
level at which you wish to
bring up the cue. (Or press
[Full])
The cue’s channels are brought up on
stage at the specified level
Prompt reads:
Group mode – Enter intensity
To Next Page
Loading...
