164 Chapter 13 Submasters
Modifying submasters in Blind
To modify a submaster in Blind, follow these steps:
Modifying submasters in Stage
Re-recording submasters
To modify a submaster in Stage with Record, follow these steps:
Keystrokes: Actions:
1. Press [Blind].
Selects Blind display
2. Press [Sub] [1].
Prompt reads:
Select submaster number
To select submaster type, press
TYPE
3. Press [Enter].
Brings up current level settings for
submaster 1
Prompt reads:
Select channel numbers
4. Enter channel numbers
and set desired new
levels.
Sets new levels
5. Press [Record].
Prompt reads:
To record submaster, select number
and press ENTER
To cancel, press CLEAR
6. Press [Enter].
Changes to submaster 1 are recorded
Keystrokes: Actions:
1. Press [Stage].
Selects Stage display
2. Use the submaster slider
to raise submaster 2 to full
on stage.
Submaster 2’s channels rise on stage
to recorded levels
3. Enter channel numbers
and set desired new levels.
New levels are set on stage
4. Press [Record], then press
submaster 2’s bump
button.
Submaster 2 is recorded with the new
levels. Submaster LED blinks,
indicating that submaster 2 has been
changed and the changes have not
been loaded
5. Press [Rel].
Releases newly set levels
6. Slide submaster slider to
zero, then back to full.
Loads submaster 2’s new levels and
brings them up on stage
To Next Page
Loading...
