ETC Express 48/96 - Wait Times in Multipart Cues

114 Chapter 9 Multipart cues
Wait times in multipart cues
You can set individual wait times of up to 99:59 minutes for each part of
a multipart cue. The wait time is the delay between when you press [Go]
and when the part begins. If no wait is recorded, all parts run
simultaneously when you press [Go].
Follow these steps to assign a wait time to a part:
Keystrokes:
Action:
1. Press [Cue], then enter the
cue number.
Selects cue number
Prompt reads:
Select cue number
2. Press [S7], More
Softkeys, until Part
appears as softkey [S1].
Finds the Part softkey
3. Press [S1], Part, then
enter the part number.
Selects part number
Prompt reads:
Select part number
4. Press [Wait] [1][0].
Selects wait time of ten seconds
Prompt reads:
Enter wait time
5. Press [Enter].
Sets wait time for the part to ten
seconds. Part will wait ten seconds,
then run