Express Two Scene Preset User Manual, v.3.1 43
Clear All
For a selected profile, Clear All changes the intensity of all fade points to
undefined.
18
Clear to End
For a selected profile, the Clear to End command sets as undefined the
intensity of all those fade points above the selected one.
18
Fill Between
When intensities in a profile are undefined, such as when you use Clear
All or Clear To End, you can use Fill Between to have them automatically
filled in with a linear profile. For Fill Between to work, you must have
defined intensities on both sides of an undefined range (zero intensity is a
defined value). Here is how Fill Between can be used to fill in undefined
intensities throughout a particular range.
Resetting a profile
Press [S7], Reset, eliminates all editing performed on a selected profile.
19
When profiles 1-9 are reset, the original relationships shown under Pre-
defined profiles, page 40, are restored. When profiles 10 through 32 are
reset, they return to linear relationships.
18.
Undefined intensities are marked ** on the Intensity line.
Keystrokes
Action
1. Press [S1], Profile, [1][5]
Selects profile 15.
2. Press [S2], Percent, [5][0]
Selects the 50% fade point.
3. Press [S4], Clear to End,
[Enter]
Changes all fade points above 50% to
undefined.
4. Press [S2], Percent, [7][5]
Selects the 75% fade point.
5. Press [At] [1][0]
Sets the 75% fade point to intensity
10
6. Press [S5], Fill Between,
[Enter]
Fills between the 50% and 75% fade
points with a straight line. Fade points
above 75% are unaffected.
7. Finish profile to end.
Set inattentiveness of fade points
between 75% and 100%
19.
You may reset all profiles at once by selecting Clear Profiles from the Clear
Functions menu.
To Next Page
Loading...
