Express Two Scene Preset User Manual, v.3.1 321
Installing an alphanumeric keyboard
Although your console does not support an alphanumeric keyboard, you
can connect a keyboard to a Remote Interface Unit or Remote Video
Interface. Use the optional keyboard to assign labels to many features of
your shows, such as to name the show and the cues, submasters, groups,
timed events and programs within it.
You can supply your own keyboard or order one from ETC. If you supply
your own, it must be an AT compatible type or switchable to an AT-
compatible mode. ETC recommends the Cherry G80-1800 and Keytronic
101 keyboards. Although you may use keyboards from other
manufacturers, ETC does not guarantee compatibility.
CAUTION
: Do not connect or disconnect an alphanumeric keyboard while
your system is turned on. Doing so may cause the keyboard to initialize
improperly.
Follow these steps to install an alphanumeric keyboard:
1. Be sure the selector switch is set to the AT position, if applicable.
2. Insert the keyboard cable into the connector labeled Keyboard on the
remote interface unit.
Console connector
DIN 5-pin female
Keyboard pinout
1Clock
2Data
3 Reset
4Ground
5+5 Vdc
To Next Page
Loading...
