ETC Express 48/96 - Modifying Macros; Clearing Macros

Express Two Scene Preset User Manual, v.3.1 233
Modifying macros
Editing mode
In the Macro mode display, you can edit macros in Insert or Replace
modes. In Insert mode, if you highlight a keystroke and type another
keystroke, the console inserts the new keystroke before the highlighted
one. In Replace mode, if you highlight a keystroke and type another
keystroke, the console replaces the highlighted keystroke with the new
one.
To switch from Insert mode to Replace mode, press [S2], Replace. To
switch from Replace mode to Insert mode, press [S2], Insert. The console
indicates the editing mode in the upper left corner of the command
display.
Editing keys
[←] and [→] move the highlight left or right when you are editing a macro.
[S3], Delete entry, deletes highlighted keystroke.
Clearing macros
You must be in Macro display mode to clear individual macros. To clear all
macros, you can use the Clear Macros option from the Clear Functions
menu, as described on , page 255.
To clear identified macros, follow these steps:
Keystrokes: Actions:
1. Press [Setup]. Selects Setup display
2. Press [8], Macro Editing,
and press [Enter].
Selects Macro display mode
3. Press [S6], Delete Macro. Prompt reads: To delete macro(s),
select macro number(s) and press
ENTER
To cancel, press CLEAR
4. Press [7].
a
a.
In step 4, you may use [And] and [Thru] to enter multiple
macros to clear.
Corner reads:
Macro 7
5. Press [Enter]. Prompt reads:
To confirm, press ENTER
To cancel, press CLEAR
6. Press [Enter]. Clears macro 7