Express Two Scene Preset User Manual, v.3.1 117
Modifying fade and wait times
If you do not assign fade and wait times to a part, the console assigns
default times.
56
No wait time will be recorded. Follow these steps to
assign fade and wait times to parts to a multipart cue:
56.
See Setting default fade times, page 24.
Keystrokes:
Action:
1. Press [Blind].
Selects Blind display mode
2. Enter the cue number.
Prompt reads:
Select cue number
To select cue type, press TYPE
3. Press [S7], More
Softkeys, until Part
appears as softkey [S1].
Finds the Part softkey
4. Press [S1], Part, then
press [+] or [-] until the part
you want to edit is
displayed.
Prompt reads:
Select part number
5. Press [Time].
Prompt reads:
Enter upfade time
6. Enter an upfade time
between .1 second and
99:59 minutes and press
[Enter].
Prompt reads:
Enter downfade time
7. If you want a downfade
time that is different from
the upfade, enter the
desired time and press
[Enter]. If not, just press
[Enter].
Fade times are set for the part
8. Press [Wait].
Prompt reads: Enter wait time
9. Enter wait time and press
[Enter]. Wait time is the
delay between when you
press [Go] and when the
part begins. If you do not
enter a wait time, the
console assigns a wait
time of zero.
Wait time is set for the part
To Next Page
Loading...
