100 Chapter 7 Cues
Inserting cues
You may want to insert a cue between recorded cues. For example, you
may want to modify cue 1 slightly and insert it between cues 1 and 2. You
can number cues with a one-digit decimal. Therefore, you can insert up to
nine cues between 1 and 2 (1.1, 1.2, etc.).
Follow these steps to insert a cue between existing cues:
Keystrokes:
Action:
1. Press [Blind] or [Stage].
Selects display mode
2. Press [Cue] and enter the
number of the cue to
modify, then press [Enter].
Selects the desired cue
3. If you are working in Stage
mode, press [Go].
Brings up cue on stage and on the
display
4. Add or modify channels
and cue attributes.
Cue is modified
5. Press [Record].
Prompt reads:
To record cue, select number and
press ENTER
To cancel, press CLEAR
6. Enter cue number with
a decimal to insert it
between cues (e.g.,
[1][.][5]). If you do not enter
a new cue number, you
will overwrite the existing
cue.
Corner reads: Cue 1.5
7. Press [Enter].
New cue 1.5 is recorded between
cues 1 and 2
To Next Page
Loading...
