104 Chapter 8 Track
Using Track
If you have tracked channels (all with the same level), you can make them
track at a different level. Also, you can track channels at a focus point, but
you cannot track through a channel set at a focus point. To illustrate,
suppose you have tracked channels as shown in the example under Using
record to create tracks, page 102. In that example, channel 1 is tracked at
full through cues 1-3. Change the tracked level of channel 1 in those cues
with the following procedure:
The results of using Track rather than Record are illustrated below. The
modified level is recorded in the current cue and carries through cues 2
and 3 until stopped at cue 4, where the level is different.
Chan 1 Chan 2 Chan 3 Chan 4 Chan 5
Cue 1 50
Cue 2 50 FF
Cue 3 50 FF FF
Cue 4 25 FF FF FF
Cue 5 00 00 00 00
Keystrokes:
Actions:
1. Press [Stage] [Rel] [Rel].
Releases captured channels
Prompt reads:
Select channel numbers
2. Press [Cue] [1] [Go].
Plays back cue 1
3. Press [1] [At] [5][0].
Modifies channel 1
4. Press [Track].
Prompt reads:
To record cue & tracking, select
number and press ENTER
To cancel, press CLEAR
5. Press [Enter].
Re-records cue 1 and tracks channel 1
into subsequent cues
To Next Page
Loading...
