Express Two Scene Preset User Manual, v.3.1 185
Editing groups
You may edit a group in the group spreadsheet. Follow all steps in the
procedure under Creating a group on the previous page except Press
[S1], Select Group in step 1.
Deleting groups
After entering the group spreadsheet as explained on the previous page,
delete a group as follows.
Replacing channel level
As a convenient editing technique, you may specify a particular level to
change for a channel or number of channels. After entering the group
spreadsheet as explained on the previous page, replace channel level as
follows.
Keystrokes: Actions:
1. Press [S6], Delete Group.
Prompt reads:
To delete group(s), select number(s)
and press ENTER
To cancel, press CLEAR
2. Press [5] [And] [6] [Enter].
Selects groups 5 and 6
Prompt reads:
To confirm, press ENTER
To cancel, press CLEAR
3. Press [Enter] [Enter].
Deletes groups 5 and 6
Keystrokes: Actions:
1. Press [S1], Select Group.
Prompt reads:
Select group(s)
2. Press [5] [Enter].
Selects group 5
Prompt reads:
Select channel(s)
3. Press [5] [Thru] [1][0] [S3],
Replace Level, [5][0].
Selects channels 5 through 10 at level
50 to change
Prompt reads:
Select level to replace and press
ENTER
4. Press [Enter].
Prompt reads:
Select new level and press ENTER
5. Press [Full] [Enter].
Changes all channels in the range 5
though 10 with level 50 to level full
To Next Page
Loading...
