Express Two Scene Preset User Manual, v.3.1 295
Creating a program using Learn Mode
Learn Mode allows you to record macro keys, submaster bump buttons
and fader [Go] keys into time code events as you go along. Because you
are making real-time decisions about the timing of events, you can record
a program live in Learn mode without specifying code times. When you
leave Learn Mode (press the Learn Mode softkey a second time), the
program is recorded with sorted event times.
Follow these steps to record a time code program in Learn mode.
112.
You can force an immediate sorting the events in the Time Code Events Display.
Press [S8], Sort, to sort the events. The sort key is in the third tier of softkeys in
this display, so if you don’t see it, press [S7], More Softkeys, until it appears at
[S8].
Keystrokes:
Actions:
1. Press [S7], until [S6] reads
Learn Mode.
2. Press [S6], Learn Mode.
TimeCd Learn flashes in red in the
upper left corner of the screen
3. If using the internal clock
to time the show, press
[S2], Clock Enable, to
start the clock.
a
a. After starting the clock, you may press [Record] to enter a
blank event.
The internal clock, in the upper right
corner of the display, starts to run
4. Go to the Stage display
5. If using an external clock,
start it now. You must
have time code input
enabled as explained
under External time code
clock, page 304.
6. Select the cues,
submasters and macros
you want to record as time
code events.
7. At the exact moment in
the program that you want
an event to begin, press
[Go] for the fader in which
you want the time code
event to run the cue, press
the submaster’s bump
button, or start the macro.
Each button press is recorded as an
event in your time code program
8. Press [Setup] [1][3] [Enter]
[S6], Learn Mode.
Returns to Time Code Events display
and deactivates Learn mode; edit the
events as necessary
To Next Page
Loading...
