RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400e Card Printer User Guide (L001172 Rev. 1.1)
4-51
Resolving the Image Placement problems (continued)
Step Procedure
3 Verify if the Horizontal Image Position Setting is set correctly or incorrectly.
See the graphic below.
• If the white border is on the leading edge of the card, adjust the
Horizontal value by +2.
• If the white border is on the trailing edge of the card, adjust the Horizontal
value by -2.
a. Click on OK.
b. Run a self-test.
c. If the white border is diminished, continue the adjustment until it is gone.
Graphic A
To Next Page
Loading...
