Fibocom G510 - Page 134

G5/G6-Family AT Commands User Manual Page
134
of
243
Read
AT+COPS?
+COPS:
<mode>[,<format
>,<oper>]
OK
or:
+CME ERROR:
<err>
The Read command returns the current mode
and the currently selected operator.
Test
AT+COPS=?
+COPS: [list of
supported
(<stat>, long
alpha numeric
<oper>,short
alphanumeric<op
er>,
numeric<oper>)]
[,list of supported
<mode>s,(list of
supported<forma
t>s)]
OK
The Test command returns a list of quadruplets,
each representing an operator present in the
network. A quadruplet consists of an integer
indicating the availability of the operator <stat>,
long and short alphanumeric format of the name
of the operator, and numeric format
representation of the operator. If any of the
formats are unavailable, there is an empty field.
The list of operators is in the following order:
home network, networks referenced in SIM or
active application in the UICC (GSM or USIM) in
the following order: HPLMN selector, User
controlled PLMN selector, Operator controlled
PLMN selector and PLMN selector (in the SIM
or GSM application), and other networks.
After the operator list, the G30 returns lists of
the supported <mode>s and <format>s. These
lists are separated from the operator list by two
commas.
The following table shows the +COPS parameters.
<Parameter>
Description
<format>
The operator format type (The default value is 0):
0 Long alphanumeric
1 Short alphanumeric
2 Numeric
<mode>
Determines whether what is displayed is defined by <oper>, or is done