Home
Fibocom
Modem
G510
Fibocom G510 User Manual
4
of 1
of 1 rating
243 pages
Give review
Manual
Specs
To Next Page
To Next Page
To Previous Page
To Previous Page
Loading...
G5/G6-Family
A
T
Com
mands
User
Manual
Page
152
of
243
[SIM1]COU
NT
:0
[SIM1]ARFCN:
0,0,0,0,
0,0,0,0,0,
0,0,0,0,0,0,0
,0,0,0,0,0,0
,0,0,0,0,0
,0,0,0,0,0
,0
OK
A
T+G
TPLMNLS=1
OK
A
T+G
TPLMNLS?
[SIM0]PLMN:
0,0,0
[SIM0]COU
NT
:0
[SIM0]ARFCN:
0,0,0,0,
0,0,0,0,0,
0,0,0,0,0,0,0
,0,0,0,0,0,0
,0,0,0,0,0
,0,0,0,0,0
,0
[SIM1]PLMN:
0,0,0
[SIM1]COU
NT
:0
[SIM1]ARFCN:
0,0,0,0,
0,0,0,0,0,
0,0,0,0,0,0,0
,0,0,0,0,0,0
,0,0,0,0,0
,0,0,0,0,0
,0
OK
151
153
Table of Contents
Default Chapter
5
Table of Contents
5
1 Preface
11
Manual Scope
11
Target Audience
11
2 Introduction to at Commands
12
AT Commands Overview
12
General System Abbreviations
12
AT Commands Protocol
12
AT Commands Structure
13
General Symbols Used in at Commands Description
13
Command Structure
13
Results Code Structure
14
Command Syntax
14
3 Modem ID
16
CGMI, +GMI, +FMI, Request Manufacturer ID
16
CGMM, +GMM, +FMM, Request Model ID
16
CGMR, +GMR, +FMR, Request Revision
17
CGSN, +GSN, Request Product Serial Number Identification
17
CSCS, Select Terminal Character Set
18
CIMI, Request IMSI
19
CFSN, Read Factory Serial Number
19
Request Identification Information
20
CNUM, Request MSISDN(S)
20
CLAC, List of All Available at Commands
21
4 Modem Control and Status
22
Modem Register Commands
22
V, Module Response Format
22
Q, Result Code Suppression
23
E, Command Echo
24
S, Bit Map Registers
25
S12
26
V, View Configuration
26
F, Set to Factory Defined Configuration
27
Z, Reset to Default Configuration
28
W, Store User Profile
28
CRSM, Restricted SIM Access
29
CCID
34
Sleep Mode Commands
35
S24, Set Number of Seconds Delay before Module Enters Sleep Mode
35
Error Handling Commands
36
CMEE, Report Mobile Equipment Error
36
CEER, Extended Error Report
37
MSTART, Start Message Notification
38
5 Call Control
39
Call Control at Commands
39
D, Dial Command
39
D>, Direct Dialing from Phone Books
40
DL, Dial Last Number
41
H, Hang-Up Call
42
A, Answer Incoming Call
43
CRC, Cellular Result Codes and RING, +CRING - Incoming Call Indication
44
CLIP, Calling Line Identification
46
CLIP Indication
46
CCWA, Call Waiting Command
48
CCWA Indication
49
CHLD, Call Related Supplementary Services Command
51
CCFC, Call Forwarding Number and Conditions
53
CLIR, Calling Line Identification Restriction
56
O, Return to Online Data State
58
CHUP, Hang up Call
59
MHUP, Module Hung up Call
60
Call Status Messages
61
CPAS, Phone Activity Status
61
CLCC, List Current Calls
62
Supplementary Services
65
CSSN, Supplementary Service Notifications
65
CUSD, Unstructured Supplementary Service Data
68
COLP, Connected Line Identification Presentation
73
6 Phone and Date Books and Clock
75
Directory Access Commands - Phone Book
75
CPBS, Select Phone Book Memory
75
This Command Handles the Selection of the Memory to be Used for Reading and Writing Entries in the Module's Phone Book's Memory
75
CPBR, Read Phone Book Entries
76
CPBF, Find Phone Book Entries
78
CPBW, Write Phone Book Entry
79
System Date and Time Access Commands
81
CCLK, Read/Set System Date and Time
81
7 Sms
83
SMS Commands
83
CPMS, Preferred Message Storage
83
CMGF, Message Format
84
CSCA, Service Center Address
85
In SMS Text Mode, SCA Stored in SIM Is Added to any Stored and Sent SMS
85
CSMP, Set Text Mode Parameters
89
CSDH, Show Text Mode Parameters
91
CNMI, New Message Indications to Terminal
92
CMTI, Unsolicited Response (New SMS-DELIVER Receipt Indication)
95
CMT, Unsolicited Response (New SMS-DELIVER Receipt)
95
CDS, Unsolicited Response (New SMS-STATUS-REPORT Receipt)
97
CMGL, +Mmgl,List Messages
98
CMGR, +MMGR, Read Message
102
CMSS, Send Message from Storage
109
CMGW, Write Message to Memory
110
CMGD, Delete Message
116
CMGS, Send SM to Network
117
8 Access and Security
119
Access Control Commands
119
A/, Repeat Last Command
119
AT, Check at Communication
119
CPIN, Enter PIN for Unlocking SIM Card or Enter PUK for Unblocking SIM Card
120
TPIN, Query Number of Remaining SIM PIN/PUK Entering Attempts
123
CPWD, Change Password
124
CLCK, Facility Lock
126
9 Network
129
Network Commands
129
CSQ, Signal Strength
129
CREG, Network Registration Status
130
CGREG, GPRS Network Registration
131
COPS, Operator Selection
133
CPOL, Preferred Operators
136
MCELL, Module Cell Description
139
MCELL Indication
140
MCI, Module Cell Information
143
MCI Indication
145
CA Indication
145
MJDC Jamming Detection
146
MJDC Indication
147
CGED, Module Cell Description
148
CBAND, Change Radio Band
149
GTPLMNLS, Clear Arfcn List
151
10 Hardware Information
153
Hardware Information Commands
153
MMAD, Query and Monitor ADC Value
153
MTSM, Temperature Sensor Measurement
154
CBC, Battery Charger Connection
156
CBAUD, Baud Rate Regulation
157
IPR, Local Terminal Serial Port Rate
158
K, RTS/CTS Flow Control
160
IFC, RTS/CTS Flow Control
161
C, Circuit 109 Behavior
162
D, Circuit 108 Behavior
163
CFUN, Shut down Phone Functionality
164
ICF, DTE-DCE Character Framing
166
MRST, Perform Hardware Power down
167
WRIM, RI Signal Width Setting
167
MSMPD, Enable/Disable SIM Card Hot Plug
169
GTWD, Enable/Disable Watchdog
170
UART2 Configuration
170
GTSET="UARTMODE", Switch UART2 Work Mode
171
GTSET="UARTREV", Report Data Mode
171
UARTSEND, Send Data to UART2
171
UART2 Use for at Command
172
11 Audio
174
Scope
174
General Audio Commands
174
CRSL, Call Ringer Level
174
CLVL, Loudspeaker Volume
175
CMUT, Mute/Unmute Microphone Path
175
S94, Sidetone Effect
176
S96, Echo Canceling
177
CALM, Alert Sound Mode
177
VTD, Tone Duration
178
VTS, Command-Specific Tone Duration
179
MAPATH, Audio Path
180
MAVOL, Volume Setting
181
MMICG, Microphone Gain Value
183
Matoneļ¼Start or Stop the Tone Play,And the Tone Plays Only Once
183
12 Gprs
185
GPRS Functionality
185
GPRS Commands
185
CGCLASS, GPRS Mobile Station Class
186
CGDCONT, Define PDP Context
187
CGQMIN, Quality of Service Profile (Min Acceptable)
189
CGQREQ, Quality of Service Profile (Requested)
191
CGATT, GPRS Attach or Detach
193
D*99, Request GPRS Service "D
194
CGACT, PDP Context Activate or Deactivate
196
CGPADDR, GPRS Addresses
197
13 Tcp/Ip
199
Basic Mode
199
MIPCALL, Create a Wireless Link
199
MGAUTH, Set Type of Authentication
201
MIPOPEN, Open a Socket (UDP or TCP)
202
MIPCLOSE, Close a Socket
205
MIPSETS, Set Size and Timeout for Automatic Push
206
MIPSEND, Send Data
208
MIPPUSH, Push Data into Protocol Stack
210
MIPFLUSH, Flush Data from Buffers
211
MIPRUDP, Receive Data from UDP Protocol Stack
212
MIPRTCP, Receive Data from TCP Protocol Stack
212
MIPDSETS, Set Size and Timeout for Output Received Data
213
MIPSTAT, Status Report
214
MIPCONF - Configure Internal TCP/IP Stack
215
MPING, Start Ping Execution (ICMP Protocol)
218
MPINGSTAT, Status Update for +MPING Execution
221
MSDNS, Set DNS IP Address
223
MIPODM, Open a Socket (UDP or TCP) in Online Data Mode
225
MIPXOFF, Flow Control - Xoff
228
MIPXON, Flow Control - Xon
228
MIPDNS, Resolve Domain Name
228
MIPNTP, Synchronize the Local Time Via NTP
229
MIPREAD, Receive Data from Buffer
230
HEX Mode
232
MIPSEND (Ctrl-Z)
232
MIPSEND (Timeout)
232
MIPSEND (Data Length)
233
GTSET, HEX Mode Configuration
234
14 Error Code
236
CME Error
236
CMS Error
239
TCP/IP Error
242
Other manuals for Fibocom G510
Hardware User Manual
42 pages
4
Based on 1 rating
Ask a question
Give review
Questions and Answers:
Need help?
Do you have a question about the Fibocom G510 and is the answer not in the manual?
Ask a question
Fibocom G510 Specifications
General
Brand
Fibocom
Model
G510
Category
Modem
Language
English
To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...
Need help?
General