Fibocom G510 - Page 198

G5/G6-Family AT Commands User Manual Page
198
of
243
Test
AT+CGPADDR=
?
+CGPADDR: (list of defined
<cid>s)
OK
The Test command returns the
list of defined <cid>s.
The following table shows the +CGPADDR parameters.
<Parameter>
Description
<cid>
A numeric parameter that specifies a particular PDP context definition. If no <cid> is
specified, the addresses for all defined context are returned.
<PDP_addres
s>
A string that identifies the MT in the address space applicable to the PDP. The
address may be static or dynamic. For a static address, it will be the one assigned
during the last PDP context activation that used the context definition referred to by
<cid>. <PDP_address> is omitted if none is available.
Example:
AT+CGPADDR=?
+CGPADDR: (1,2)
OK
AT+CGPADDR=1
+CGPADDR: 1,”0.0.0.0”
OK