Fibocom G510 - Page 219

AT Commands User Manual Page
219
of
243
displayed, otherwise default parameter
values will be displayed
Test
+MPING=?
+MPING:
<count>,<size>,<TTL>
,<TOS>,<TimeOut>
OK
The test command displays all supported
parameters values for +MPING set
command.
The following table shows the +MPING command parameters.
<Parameter>
Description
<mode>
0 - Abort current ping request execution.
1 - Launch new ping request.
There is no default value - appropriate ERROR will be displayed if parameter is
not supplied.
<"Destination_IP/hos
tname">
Specifies the target machine (computer), which is identified either by IP
address 4 octets long in dotted decimal notation or by host name of maximum
255 (not including double quotes) characters long in dotted notation. Each octet
of IP address has valid value range of 0 to 255. Host names are not case
sensitive and can contain alphabetic or numeric letters or the hyphen. There is
no default value - appropriate ERROR will be displayed if parameter is not
supplied.
<count>
Specifies a number of Internet Control Message Protocol (ICMP) Echo
Request messages to send. Valid value range is from 1 to 255.
The default value is 4.
<size>
Specifies the length, in bytes, of the Data field in the Echo Request messages
sent. The minimum size is 0.The maximum size is 1372.
The default value is 32.
<TTL>
Time To Live (TTL). Specifies number of hops (hop is one step, from one router
to the next, on the path of a datagram on an IP network), which the Echo
Request message may be routed over. The value is set by using TTL field in IP
header. Valid value range is from 1 to 255.
The default value is 64.
<TOS>
The Type Of Service (TO S) is for internet service quality selection. The type of