Fibocom G510 - Page 226

AT Commands User Manual Page
226
of
243
<Pseudo-Command
Mode On/Off>
Port>]
or:
+MIPSTAT:
<Socket_ID>,<Status>
or:
ERROR: <err>
mode.
Read
AT+MIPODM?
+MIPODM:[<Socket_ID>]
for each socket that can be
opened
or:
+MIPODM 0,0
if there are no free sockets.
When a socket opens in
Online Data Mode, the
command returns actual
Socket_ID value a‘d’'1'
value (active). Module will
be in pseudo-command
mode for receiving the
command.
Test
AT+MIPODM=?
+MIPODM: (list of supported
<socket_ID>s),(list of supported
<source port>s),(list of
support”d<"Destination”IP">s),
(list of <destination port>s),(list of
supported <protocol>s), (list of
supported <Pseudo-Command
Mode state>s)
The following table shows the +MIPODM parameters.
<Parameter>
Description
Socket_ID
A unique number that identifies a connection.
Valid socket number–s - 1,2,3 and 4
Source Port
Port of source site.
Port range: 1-65535 (decimal digits)
Remote IP
IP of the remote site in the form“t "AAA.BBB.CCC.”DD". The range of each
octet is 0-255. The value can be written in 1, 2, or 3 digits.
Host-name of remote site. The host-name convention should meet the rules