Fibocom G510 - Page 57

G5/G6-Family AT Commands User Manual Page
57
of
243
1 - CLIR invocation
2 - CLIR suppression
The default value is 2.
<m>
Subscriber CLIR service status in the network
0 - CLIR not provisioned
1 - CLIR provisioned in permanent mode
2 - Unknown (for example, no network and so on)
3 - CLIR Temporary mode presentation restricted (can be the default)
4 - CLIR Temporary mode presentation allowed (can be the default)
Example:
AT+CLIR=?
+CLIR: (0-2)
OK
AT+CLIR?
+CLIR: 0,0
OK
AT+CLIR=2
OK
atd054565195; //MO voice call
OK
(… calling …)
(… a Module that has 054565195 SIM and is CLIP enabled will receive the following on the
terminal:
RING
+CLIP: "",128,,128,"",1
RING
+CLIP: "",128,,128,"",1)
ath
NO CARRIER
OK
AT+CLIR=0
OK
atd054565195; //MO voice call
OK