Fibocom G510 - Page 93

G5/G6-Family AT Commands User Manual Page
93
of
243
The following table shows the +CNMI parameters.
<Parameter>
Description
<mode>
0 Buffer unsolicited result codes in the TA; if the TA buffer is full, the oldest
indication may be discarded and replaced with the new received indications
(ring buffer).
1 Discard indication and reject new received message unsolicited result
codes when TA-TE link is reserved; otherwise forward them directly to the
terminal.
2 buffer unsolicited result codes in the TA when the serial link is busy (e.g.
data-transfer); otherwise forward them directly to the terminal.
<mt>
0 No SMS-DELIVER indications are routed to the terminal (default)
1 If SMS-DELIVER is stored in the Module, the memory location indication is
routed to the terminal using the unsolicited result code: +CMTI:
<mem>,<index>
2 SMS-DELIVER (except class2 SMS) are routed directly to the TE using
the unsolicited result code:
+CMT: [<alpha],<length><CR><LF><pdu> (in PDU mode)
or
+CMT:
<oa>,[<alpha>],<scts>[,<tooa>,<fo>,<pid>,<dcs>,<sca>,<tosca>,<length
>]<CR><LF>
If ME has its own display device then class 0 SMS and SMS in the
message waiting indication group (discard message) may be copied to
both ME display and to terminal. In this case ME shall send the
acknowledgement to the network. Class 2 SMSs and messages in the
message waiting indication group (storage message) result in indication as
defined in <mt>=1
<bm>
0 No CBM indications are routed to the terminal (default)
<ds>
0 No SMS-STATUS-REPORT indications are routed to the terminal (default)
1 SMS-STATUS-REPORT is routed directly to the terminal
<bfr>
0 TA buffer of unsolicited result codes defined within this command is
flushed to the TE when <mode> 1...3 is entered (OK response shall be
given before flushing the codes).