Fluke 54200 - 54200 Standard Event Status Register

Remote Control
Remote Control Commands
6
6-15
54200 ‘Standard Event Status Register’
<NR1> represents a decimal value. The binary pattern of the decimal value sets the
corresponding bits of the 'Enable Registers' to 1, which enables the bits of the 'Status
Registers'.
All bits of the 'Standard Event Status Enable Register' and the 'Service Request Enable
Register' are automatically set to 0 when powering up the instrument. Therefore, in a user
program it is necessary that the required bits are set to 1 after power-on, if Service
Request is required.