Fluke 54200 - Error Messages

54200
Users Manual
6-50
Error Messages
After receiving the query
ERR?
the instrument generates a response message with an
error number and an error description in clear text, which can be read in by the controller.
Error Message See Page
Illegal Character in Header No... ....................................................... 6-16 to 6-43
Unknown Header No... ...................................................................... 6-16 to 6-43
Unexpected Separator in Header No... ............................................... 6-13
Illegal Character in Data for Header... ............................................... 6-21 to 6-43
Unknown Data for Header.... ............................................................. 6-16 to 6-42
Unexpected Separator in Data for Header... ....................................... 6-13
Unknown Suffix in Data for Header.... .............................................. 6-16 to 6-32
Numeric Overflow in Data for Header... ............................................ 6-21
Empty Mantissa in Data for Header... ................................................ 6-21
Empty Exponent in Data for Header... ............................................... 6-21
Value out of Range in Data for Header... ........................................... 6-16 to 6-40
Illegal Value in Data for Header... ..................................................... 6-21 to 6-40
Header Separator expected after Header... ......................................... 6-13
Data Separator expected after Header.... ............................................ 6-13
End of String expected in Data for Header ... .................................... 6-13
Message Separator expected after Header... ....................................... 6-13
Too many queries, Query ... .............................................................. 6-21
Too many Pattern Commands, Header No. ... .................................... 6-27
Too many *SAV Commands, Header No. ... ..................................... 6-21
Option not available, Query ... .............................................................. 6-41 to 6-43
*OPT? query must be last in Message, Header No. ... ....................... 6-16
In addition to this error messages the instruments generates messages in clear text if
commands were sent with values exceeding the allowed ranges or for not allowed
settings, for example, ‘Sound Mode not available for Mono Systems’ if you send the
command for sound mode stereo when sound system FM Mono is selected, see
Chapter 5, Operating Hints, ‘Out of Range and Error Messages.’