How to Use the Instrument
Operating via Keyboard
4
4-13
•
Press the
é
or
ê
softkey (F1 or F2) to select the required sound mode.
•
Press the
enter
softkey (F5) to confirm your selection.
Figure 4-18. Selected Sound Mode
•
Use the
é
or
ê
softkey (F1 or F2) and the
edit
softkey (F3) to select the sound
parameters like modulation frequency (
CH1
and
CH2
), the pre-emphasis, and the
sound carrier level (
SC-Level
).
•
Press the
enter
softkey (F5) to confirm your selection.
You can also select the sound mode directly with the
SOUND
keys
MONO
,
DUAL/SAP
,
and
STEREO
.
Pressing the
INT/EXT
key briefly, toggles to the internal modulation frequency source, if
an external source was selected. Pressing this key briefly if the internal modulation
frequency source is selected, toggles to the last selected external source, for example,
SCART. Pressing this key longer than one second, calls up the popup menu for the
modulation frequency source selection.
For details about external sound sources, see Chapter 5, ‘External Sound Modulation’.
Pressing the
CH1
and
CH2
keys briefly, switches the modulation frequency of the left
and right sound channels on or off. Pressing these keys longer than one second, calls up
the popup menu for the sound modulation frequency selection.
For details about sound parameter settings, see the table in Chapter 5, ‘Sound Operating
Modes.’
To Next Page
Loading...