TX140 S1 Upgrade and Maintenance Manual 101
Basic software procedures
Ê After completion of the flash process, remove the USB stick and restart the
server.
BIOS recovery procedure
I For the Japanese market, follow the instructions provided separately.
Ê Prepare a USB stick with the following files:
– Update tool
– Startup.nsh (which will execute the update tool)
– BIOS image file for update (16 MB with header information)
Ê Ensure that the server has been shut down and disconnected from the
mains as described in section "Shutting down the server" on page 61.
Ê Open the side / top cover as described in section "Opening the server" on
page 67.
Ê Enter BIOS recovery mode using the onboard jumpers.
I For detailed information on jumper settings, refer to section "Onboard
settings" on page 577.
Ê Close the side / top cover as described in section "Closing the server" on
page 77.
Ê Connect the USB stick to the USB port.
Ê Connect the server to the mains as described in section "Connecting the
server to the mains" on page 90.
Ê Press the On / Off button to start up the server.
The system will detect the USB stick and the BIOS recovery process will be
performed.
V CAUTION!
Do not interrupt the BIOS recovery process after it has started. If the
process is interrupted, the system BIOS may be permanently
corrupted.
Ê After completion of the flash process, shut down the server.
Ê Open the side / top cover as described in section "Opening the server" on
page 67.
Ê Disable BIOS recovery mode using the onboard jumpers:
To Next Page
Loading...
Need help?
General