TX140 S1 Upgrade and Maintenance Manual 179
Hard disk drives / solid state drives
7.3.2.5 Concluding steps
Perform the following procedures to complete the task:
Ê When working on a tower server, close the HDD bay cover as described in
section "Installing the HDD bay cover" on page 84.
Ê Please observe the notes on RAID rebuild in section "Performing a RAID
array rebuild" on page 117.
Ê If applicable, close the rack door as described in section "Closing the rack
door" on page 92.
7.3.3 Removing 3.5-inch HDD modules
7.3.3.1 Required tools
● Preliminary and concluding steps: tool-less
● Removing a 3.5-inch HDD module: tool-less
7.3.3.2 Preliminary steps
Before removing a 3.5-inch HDD module, perform the following steps:
Ê Ensure that the HDD module to be removed is not combined into a RAID
array. If the drive is part of a RAID array, you first need to delete the array
using ServerView RAID Manager.
V CAUTION!
All data on all HDDs in the array will be lost! Be sure to back up your
data before deleting a RAID array.
I For further information, please refer to the "ServerView Suite RAID
Management" user guide, available from the ServerView Suite
DVD 2 supplied with your PRIMERGY server or online at
Customer Replaceable Units (CRU)
Average task duration: 5 minutes
To Next Page
Loading...
Need help?
General