Fujitsu PRIMERGY TX140 S1 - Switching on the ID Indicator

TX140 S1 Upgrade and Maintenance Manual 99
Basic software procedures
5.1.6 Switching on the ID indicator
When working in a datacenter environment, switch on the ID indicator on the
front and rear connector panels of the server for easy identification.
I For further information, refer to section "Locating the defective server" on
page 54 or to the "ServerView Suite Local Service Concept (LSC)"
manual available from the ServerView Suite DVD 2 supplied with your
PRIMERGY server or online at http://manuals.ts.fujitsu.com (EMEA
market) or http://jp.fujitsu.com/platform/server/primergy/manual/ (Japanese
market).
Using the ID button on the front panel
Ê Press the ID button on the front panel to switch on the system identification
LEDs.
I For further information, refer to section "Front panel controls and
indicators" on page 584.
Using ServerView Operations Manager
Ê In ServerView Operations Manager Single System View and press the Locate
button in the title bar to switch on the ID indicators.