Fujitsu PRIMERGY TX140 S1 - Preparing the Slide-In Unit

338 Upgrade and Maintenance Manual TX140 S1
Accessible drives
Figure 192: Mounting the slimline ODD in the slide-in unit (B)
Ê Fasten it with two M2 x 2.5 mm screws to the slide-in unit on the left side..
12.2.5.2 Preparing the slide-in unit
Removing EasyClick rails from the dummy cover
I Slide-in units are supplied without EasyClick rails. Before installing a new
slide-in unit, EasyClick rails need to be removed from the dummy cover
and mounted on the slide-in unit.