EasyManua.ls Logo

Fujitsu PRIMERGY TX140 S1 - Converting a Standard Power Supply to a Redundant Power Supply; Required Tools

Fujitsu PRIMERGY TX140 S1
588 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX140 S1 Upgrade and Maintenance Manual 135
Power supply
6.2 Converting a standard power supply to a
redundant power supply
The standard power supply can be replaced by a redundant power supply. The
redundant power supply consists of up to two PSU modules. The upgrade kit
contains only one PSUmodule (for power supply redundancy the second PSU
module must be additionally ordered).
The upgrade kit for the redundant power supply consists of the following parts:
PSU cage with power distribution board (incl.power cables)
one PSU module
dummy cover (if only one power supply module is installed, you have to
install the dummy cover in the second bay)
several screws
6.2.1 Required tools
Preliminary and concluding steps: tool-less
Converting a standard power supply to a redundant power supply:
Phillips PH2 / (+) No. 2 screw driver
Field Replaceable Units (FRU)
Average task duration: 10 minutes

Table of Contents

Other manuals for Fujitsu PRIMERGY TX140 S1

Related product manuals