EasyManua.ls Logo

Fujitsu PRIMERGY TX140 S1 - Closing the Server; Rack Model; Mounting the Rack Front Cover

Fujitsu PRIMERGY TX140 S1
588 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TX140 S1 Upgrade and Maintenance Manual 77
Basic hardware procedures
4.6 Closing the server
V CAUTION!
Before attaching the covers, make sure no unnecessary parts or tools
are left inside the server.
In order to comply with applicable EMC regulations (regulations on
electromagnetic compatibility) and satisfy cooling requirements, the
PRIMERGY TX140 S1 server must not run while the top / side cover
is removed.
For further safety information, please refer to chapter "Important
information" on page 41.
4.6.1 Rack model
4.6.1.1 Mounting the rack front cover
Figure 23: Installing the rack front cover (A)
Ê Hook the three tabs on the rack front bezel into the notches in the chassis.

Table of Contents

Other manuals for Fujitsu PRIMERGY TX140 S1

Related product manuals