474 Upgrade and Maintenance Manual TX140 S1
Converting a tower server to a rack server
15.2 Preliminary steps
Before converting the server model, perform the following steps:
Ê Disable BitLocker functionality as described in section "Disabling BitLocker
functionality" on page 93.
Ê Shut down the server as described in section "Shutting down the server" on
page 61.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section "Disconnecting power cords" on page 63.
Ê Remove all external cables.
Ê Open the side cover as described in section "Removing the side cover" on
page 71.
Ê Pull out the ID card and open the front cover as described in section
"Removing the front cover" on page 74.
I The front cover is no longer required.
To Next Page
Loading...
