TX140 S1 Upgrade and Maintenance Manual 489
16 Cabling
This chapter provides information on how to connect, disconnect and route
cables.
Safety notes
V CAUTION!
● Always hold cables by their connectors when disconnecting them.
Never pull on the cable to disconnect cables.
● Ensure that none of the cables are scraped, strained or otherwise
damaged while replacing system components.
● Immediately replace cables with damaged shielding.
● Always use shielded network cables.
In this chapter
● "Cabling overview" on page 490
● "Replacing the front panel cable" on page 500
● "Replacing the power cable" on page 510
● "Replacing the ODD SATA cable" on page 523
● "Replacing SAS / SATA backplane cables" on page 529
● "Replacing the backup drive USB cable" on page 539
● "Replacing BBU cables" on page 546
● "Replacing the front LAN cable" on page 545
● "Replacing the intrusion switch cable" on page 560
To Next Page
Loading...
Need help?
General