30 Upgrade and Maintenance Manual TX140 S1
Before you start
Replacing a defective component
The global error indicators on the front and rear sides of the server as well as
local diagnostic LEDs on the front panel report defective hardware components
that need to be replaced. For further information on the controls and indicators
of your server, refer to the "PRIMERGY TX140 S1 Server Operating Manual"
and section "Connectors and indicators" on page 575.
If the system has been powered off in order to replace a non-hot plug unit, a
system of PRIMERGY diagnostic indicators guides you to the defective
component. The "Indicate CSS" button enables the indicator next to the
defective component even if the server has been switched off and disconnected
from the mains. For further information, please refer to sections "Using
diagnostics information" on page 53 and "Connectors and indicators on the
front panel" on page 583.
If the defective component is a customer replaceable unit included in the CSS
concept (Customer Self Service, only available for EMEA market), the CSS
indicators on the front and rear side of the server will light up.
For further information, refer to the "ServerView Suite Local Service Concept
(LSC)" manual available from the ServerView Suite DVD 2 supplied with your
PRIMERGY server or online at http://manuals.ts.fujitsu.com (EMEA market) or
http://jp.fujitsu.com/platform/server/primergy/manual/ (Japanese market).
It is recommended to prepare local maintenance tasks using remote diagnostics
procedures, as described in the "ServerView Suite Local Service Concept
(LSC)" manual.
To Next Page
Loading...
Need help?
General