Garmin CIRRUS PERSPECTIVE TOUCH+ - Recording Mode

Cockpit Reference Guide for the Cirrus SR2x with Perspective Touch+ by Garmin
190-02954-01 Rev. A 171
Additional Features
Flight
Instruments EIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazard
Avoidance AFCS
Additional
Features Annun/Alerts Appendix Index
Flight
Instruments EAS
Audio and
CNS
Flight
Management
Hazard
Avoidance AFCS
Additional
Features
Abnormal
Operation Annun/Alerts Appendix Index
1) From MFW Home, touch Services > Connext Setup.
2) On the Settings Tab, a green annunciator below the PED Flight Plan Imports Button
indicates PED flight plan importing is enabled. Pressing the PED Flight Plan Imports
Button cycles this function either ‘on’ or ‘off.’
Enabling/Disabling Wi-Fi Database Importing from Garmin Pilot:
1) From MFW Home, touch Services > Connext Setup.
2) On the Settings Tab, a green annunciator below the Database Imports Button indicates
Wi-Fi Database Importing is enabled. Pressing the Database Imports Button cycles this
function either ‘on’ or ‘off.’
Removing a specific paired device from the list of paired devices:
1) From MFW Home, touch Services > Networks & Pairing.
2) Touch the Bluetooth Settings Button.
3) While viewing the ‘Internal Network Settings’ Screen, touch Devices Tab.
4) Touch the Bluetooth device name to be removed.
5) A confirmation screen is displayed asking to remove the paired Bluetooth device.
6) Touch OK to remove the device from the list of paired devices.
RECORDING MODE
NOTE: For monitored audio to be recorded, the device must be connected to GMA-1
over a Bluetooth connection.
Enabling a Bluetooth Device as a recording device:
1) From MFW Home, touch Services > Networks & Pairing.
2) While viewing the ‘Networks & Pairing’ Screen, touch the Bluetooth Settings Button.
3) On the ‘Internal Network Settings’ Page, touch the Select Device Button.
4) From the ‘Device Selection List’ touch the GMA 1 Button.
5) With GMA 1 selected, touch Devices Tab on the ‘Internal Network Settings’ Page.
6) Follow the ‘Connecting a PED to the aircraft’s Bluetooth System’ Procedure and connect
the PED to GMA 1.
7) Toggle the Recording Device Enable Button next to the device in the ‘Bluetooth Device
Name and Status’ List to allow headset audio to be recorded over the GMA-1 Bluetooth
connection to the PED.
8) A green annunciator indicates the device has been enabled for recording.