Garmin CIRRUS PERSPECTIVE TOUCH+ - Managing Flight Plans

Cockpit Reference Guide for the Cirrus SR2x with Perspective Touch+ by Garmin
190-02954-01 Rev. A 77
Flight Management
Flight
Instruments EIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazard
Avoidance AFCS
Additional
Features Annun/Alerts Appendix Index
Flight
Instruments EAS
Audio and
CNS
Flight
Management
Hazard
Avoidance AFCS
Additional
Features
Abnormal
Operation Annun/Alerts Appendix Index
a) Touch the Flight Plan Options Button.
b) Touch Load & Activate Standby Button.
c) Touch the OK Button in response to the 'Active Standby Flight Plan < flight plan
leg >.' prompt and return to the 'Flight Plan Plan' Screen. The standby flight plan
is copied to the active flight plan and new direct-to guidance is provided to the
previously linked waypoint. If there was no P. POS link in the standby flight plan, the
system chooses which waypoint to create a direct-to instead.
MANAGING FLIGHT PLANS
Importing and Exporting Flight Plans
Ignoring a pending flight plan transfer from a wireless connection:
1) When a flight plan transfer has been initiated from a mobile device, the notification
button will change to a flashing Connext
®
Button on the Touchscreen Controller, and a
Connext annunciation appears on the PFW.
2) Touch the Connext Button to see the notification of the pending flight plan on the
'Notifications' Screen.
3) Touch the Connext Button again to ignore the pending flight plan and return to the
previous screen. The pending flight plan is not loaded into the system, though the
notification message will still remain on the 'Notifications' Screen under the Connext Tab
for future use.
Viewing and activating a pending flight plan from a wireless connection:
1) When a flight plan transfer has been initiated from a mobile device, the notification
button will change to a flashing Connext Button on the Touchscreen Controller, and a
Connext annunciation appears on the PFW.
2) Touch the Connext Button to see the notification of the pending flight plan on the
'Notifications' Screen.
3) Touch the Flight Plan Received Button to preview and add the pending flight plan to
the standby flight plan. If there is already a loaded standby flight plan, a pop up window
will confirm 'Replace Standby Flight Plan?'. Touch OK to continue.
4) The 'Standby Flight Plan' Screen is now shown on the Touchscreen Controller containing
the flight plan which was transferred from the mobile device.
5) Load the Standby Flight Plan, or Load and Activate the Standby Flight Plan:
Touch the Load Standby Button. The Standby will replace the Active Flight Plan and
vice versa.
Or:
Touch Flight Plan Options > Load Standby. The Standby will replace the Active
Flight Plan and vice versa.
Or: