Cockpit Reference Guide for the Cirrus SR2x with Perspective Touch+ by Garmin
190-02954-01 Rev. A
26
Audio and CNS
Flight
InstrumentsEIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazard
AvoidanceAFCS
Additional
FeaturesAnnun/AlertsAppendixIndex
Flight
InstrumentsEAS
Audio and
CNS
Flight
Management
Hazard
AvoidanceAFCS
Additional
Features
Abnormal
OperationAnnun/AlertsAppendixIndex
2) Touch the Name Button to change the name if desired.
3) Touch the Add to Favorite Button.
Selecting a COM frequency from favorites:
1) From NAV/COM Home, touch the Find Button.
2) Touch the Favorite Tab.
3) Touch the desired Frequency Button.
4) Touch the Enter Button to accept the new frequency as the standby frequency.
Removing a COM frequency from Favorites:
1) From NAV/COM Home, touch the Find Button.
2) Touch the Favorite Tab.
3) Touch the X Button next to the frequency to be deleted.
4) Touch the OK Button to confirm.
Changing COM frequency channel spacing:
1) From MFW Home, touch Utilities > Setup > Avionics Settings.
2) Touch the System Tab.
3) Touch the COM Channel Spacing Button.
4) Select desired spacing (8.33 kHz or 25.0 kHz).
NAV OPERATION
Selecting/deselecting a navigation radio for monitoring:
1) From NAV/COM Home, touch the Audio & Radios Button to display the ‘Audio & Radios’
Screen.
2) Touch the NAV1 Button or NAV2 Button to select/deselect the radio for monitoring.
Tuning a NAV frequency from the ‘Audio & Radios’ Screen:
1) From NAV/COM Home, touch the Audio & Radios Button to display the ‘Audio & Radios’
Screen.
2) Touch the NAV1 or NAV2 Frequency Button to display the NAV1 or NAV2 Standby Screen.
3) Use the keypad to select the desired frequency.
4) Touch the Enter Button to accept the new frequency as the NAV1 or NAV2 standby
frequency:
Transferring the active and standby NAV frequencies:
1) From NAV/COM Home, touch the Audio & Radios Button to display the ‘Audio & Radios’
Screen.
2) Touch the NAV1/NAV2 Frequency Button to display the NAV1/NAV2 Standby Screen.
3) Touch the XFER Button or push and hold the small upper knob to transfer the
frequencies.
To Next Page
Loading...
