Garmin CIRRUS PERSPECTIVE TOUCH+ - Page 102

Cockpit Reference Guide for the Cirrus SR2x with Perspective Touch+ by Garmin
190-02954-01 Rev. A
76
Flight Management
Flight
InstrumentsEIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazard
AvoidanceAFCS
Additional
FeaturesAnnun/AlertsAppendixIndex
Flight
InstrumentsEAS
Audio and
CNS
Flight
Management
Hazard
AvoidanceAFCS
Additional
Features
Abnormal
OperationAnnun/AlertsAppendixIndex
5) Touch the Flight Plan Options Button.
6) Touch the Invert Button. Touch the OK Button to continue. The flight plan and flight
plan comment is inverted (all procedures are removed). Touch the Back Button to save
the changes and return to the 'Flight Plan Catalog' Screen.
Using the Standby Flight Plan
Viewing the active and standby flight plan screen:
1) From MFW Home, touch Flight Plan.
2) Touch the Standby Flight Plan Button to display the 'Standby Flight Plan' Screen.
3) Touch the Active Flight Plan Button to return to the 'Active Flight Plan' Screen.
Linking aircraft present position (Insert P. POS Link) to the standby flight plan:
1) From MFW Home, touch Flight Plan > Standby Flight Plan.
2) Touch the desired Waypoint Selection Button to link the aircraft present position to a
waypoint.
3) Touch the Insert P. POS Link Button.
4) A P. POS Button is added to the standby flight plan with a white arrow drawn to indicate
the link created. To change the waypoint that P. POS is linked to, repeat Steps 2 through
4 for the desired waypoint.
Removing P. POS link from the standby flight plan:
1) From MFW Home, touch Flight Plan > Standby Flight Plan.
2) Touch the P. POS Button.
3) Touch the Remove P.POS Link Button.
4) Touch the OK Button in response to 'Remove link from P. POS?'. To cancel the request,
touch the Cancel Button.
Loading and activating the standby flight plan:
1) From MFW Home, touch Flight Plan > Standby Flight Plan.
2) Load the Standby Flight Plan and preserve previous active leg guidance:
a) Touch the Load Standby Button.
Or:
Touch Flight Plan Options > Load Standby.
b) Touch the OK Button in response to the 'Load Standby Flight Plan and Replace Active
Flight Plan.' prompt and return to the 'Flight Plan Plan' Screen. The standby flight
plan is copied to the active flight plan, and an off-route direct-to leg is created for the
previously active leg.
Or:
Load the Standby Flight Plan and create new direct-to leg guidance: