Garmin CIRRUS PERSPECTIVE TOUCH+ - Page 50

Cockpit Reference Guide for the Cirrus SR2x with Perspective Touch+ by Garmin
190-02954-01 Rev. A
24
Audio and CNS
Flight
InstrumentsEIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazard
AvoidanceAFCS
Additional
FeaturesAnnun/AlertsAppendixIndex
Flight
InstrumentsEAS
Audio and
CNS
Flight
Management
Hazard
AvoidanceAFCS
Additional
Features
Abnormal
OperationAnnun/AlertsAppendixIndex
3) Turn the large and small upper knobs to select the frequency (Large knob increases/
decreases MHz; Small knob increases/decreases kHz).
4) If desired, push and hold the small upper knob to accept the new frequency as the active
frequency and transfer the previously active frequency to the standby frequency.
Transferring the active and standby COM frequencies:
From NAV/COM Home, touch the COM1 Button or COM2 Button to transfer the standby
and active frequencies.
Or:
1) From NAV/COM Home, push the small upper knob to select the standby COM desired for
transfer (selected standby frequency is cyan).
2) Push and hold the small upper knob to transfer the standby frequency to the active
frequency.
Or:
1) From NAV/COM Home, touch the Audio & Radios Button to display the ‘Audio & Radios’
Screen.
2) Touch the COM1 or COM2 Volume Slider Button to select the radio for frequency transfer.
3) Push and hold the small upper knob to transfer the frequencies.
Selecting the Sync to Pilot Button:
1) From NAV/COM Home, touch the Audio & Radios Button to display the ‘Audio & Radios’
Screen.
2) Touch the Copilot Tab or Pass Tab.
3) Touch the Sync to Pilot Button. ‘Audio & Radios’ Screen Buttons are not available to the
copilot or passengers when Sync to Pilot Button is enabled.
Finding and selecting a COM frequency using the Find Button:
1) From NAV/COM Home, touch the Find Button to display the ‘Find COM Frequency’
Screen.
2) Touch the tab for the desired type of frequency (Recent, Nearest, Dest, Flight Plan, or
Favorite).
3) Scroll the list to find the desired frequency.
4) Touch the Frequency Button to accept the new frequency as the COM1 or COM2 standby
frequency.
Finding and selecting a COM frequency from the ‘Airport Information’ Screen:
1) From MFW Home, touch Waypoint Info > Airport to display the ‘Airport Information’
Screen.
2) If needed, touch the airport button to enter or find the desired airport.
3) Touch the Freqs Tab to display the ‘Airport Frequencies’ Screen.