Garmin CIRRUS PERSPECTIVE TOUCH+ - Page 78

Cockpit Reference Guide for the Cirrus SR2x with Perspective Touch+ by Garmin
190-02954-01 Rev. A
52
Flight Management
Flight
InstrumentsEIS
Nav/Com/
XPDR/Audio
Flight
Management
Hazard
AvoidanceAFCS
Additional
FeaturesAnnun/AlertsAppendixIndex
Flight
InstrumentsEAS
Audio and
CNS
Flight
Management
Hazard
AvoidanceAFCS
Additional
Features
Abnormal
OperationAnnun/AlertsAppendixIndex
1) From MFW Home, touch Flight Plan.
2) Touch the ¯ Button to display the 'Direct To' Screen with the active flight plan
waypoint selected the direct-to destination.
3) Touch the Activate ¯ Button to activate the direct-to.
Selecting a waypoint as a direct-to destination using the Map Pointer:
1) Push the lower knob to display the pointer.
2) Place the map pointer at the desired destination location.
3) If the pointer is placed on a waypoint, the waypoint ID is highlighted, and the ¯
Button is activated.
Or:
If the pointer is placed over multiple map items.
Touch the Prev or Next Button to cycle to the desired waypoint.
Or:
a) Touch the Map Item Button to open the 'Map Item Selection' Screen.
b) Touch the desired waypoint.
4) Touch the ¯ Button to display the 'Direct To' Screen with the selected point entered as
the direct-to destination.
5) To activate direct-to navigation:
Touch the Activate ¯ Button to activate the direct-to.
Or:
a) Touch the Activate and Insert in Flight Plan Button or the Insert in Flight Plan
Button (only available if the selected waypoint is not in the flight plan) to display the
'Insert and Activate ¯ <waypoint> Before?' Window.
b) Touch the Waypoint Selection Button to select the flight plan location to insert the
direct to waypoint, and to activate the direct-to.
Removing a Direct To:
1) From MFW Home, touch ¯ on the Button Bar.
2) Touch the Remove ¯ Button.
3) Touch the OK Button in response to the question “Remove ¯ <waypoint>”.
Selecting a manual direct-to course:
1) From MFW Home, touch ¯ on the Button Bar.
2) If necessary, touch the Waypoint Selection Button to enter the waypoint as the direct-to
destination. Then, touch the Course Button to display the keypad.
3) Touch the Course or Radial Button.