GE MEDICAL SYSTEMS
D
IRECTION 2392751-100, REVISION 3VIVID™ 4 SERVICE MANUAL
Chapter 7 - Diagnostics/Troubleshooting 7-87
7-5-2-1 Service Log In
1) From the System Configuration window, make sure that iLinq (the Common Service platform) is
enabled under the Technical Support tab, as shown in Figure 7-58 below.
Figure 7-58 Technical Support - System Configuration
2) Trackball to OK and press Select. The System Configuration window closes.
Note: If iLinq was not found to be enabled in step 1, it is necessary to re-boot the system before
proceeding.
3) Trackball to the wrench icon in the status bar at the bottom of the scanning screen and press
Select.
The Profile Manager window is displayed, as shown in Figure 7-59 on page 7-88.
To Next Page
Loading...
