GE Vivid 4 BT03 RFI - Panasonic VCR Replacement Procedure; Manpower; Preparations; Tools

GE MEDICAL SYSTEMS
D
IRECTION 2392751-100, REVISION 3VIVID™ 4 SERVICE MANUAL
8-130 Section 8-8 - Peripherals
8-8-4 Panasonic VCR Replacement Procedure
NOTE: This section describes the installation and removal procedure of the Panasonic AG-MD-835E (PAL) and
AG-MD-835P (NTSC) video cassette recorders.
The installation and removal procedures are the same for both models.
NOTE: IMPORTANT - Before installation of either Panasonic VCR model, it is necessary to order the
Panasonic VCR RS-232 Adaptor (Part No. 066E8200).
Figure 8-123 Panasonic Video Cassette Recorder (VCR)
8-8-4-1 Tools
No special tools needed.
8-8-4-2 Manpower
One person - 30 mins.
8-8-4-3 Preparations
1) Shut down the Vivid™ 4 ultrasound unit, as described in Chapter 3 - Installation.
2.) Remove the Connectors Panels Cover as described in the Connector Panels Cover Removal
Procedure on page 8 - 8.
3.) Unpack the VCR.
4.) Check that the VCR AC voltage corresponds to that of your local voltage.
5.) Verify that the switches on the VCR front switch panel are as shown in Figure 8-124 on page 8-131.
If necessary, adjust accordingly.